With the subframe on the vehicle, it is a fairly simple job to get the bulkhead on the chassis and start planning the bodywork. With the bulkhead in place, I could lift the rear body section into position to locate the new body mounts properly.
The clearances are all pretty close, but they are going to be workable. The plan for the vehicle is a proper double cab set up with dropsides on the rear, so the next phase will be sorting out all the framework and body panels for the cab area. It is going to be a lot of work, but hopefully the end result will be worthwhile.
In the meantime, a few pictures for you !
Comment feed for this post